Section 8 Spare Parts
Model 310 Series DH Incubator 8-1Thermo Scientific
Part Number Description
190699 Removable feather gasket
190670 Duct sheet and shelf channel kit
190772 Micro board, (main control)
230135 Fuse, 1A, TD, 5 x 20mm
230120 0.5A fuse, TD, 5 x 20mm (accessory outlet)
230161 Fuse, 5A, 5 x 20mm
156126 Motor, 2-pole, 115VAC, 50/60 Hz
190793 Display board
290184 Probe, 2252 Ohm/25°C, 1/8 x2
770001 Disposable filter, 99.97 (CO2 line, air sample)
760175 HEPA filter, 5.5” diameter
760199 HEPA2 VOC Filter Replacement Kit (includes 760200 HEPA2, 117036 silicone plug, 101018 o-ring)
1900067 Filter Replacement Kit (includes [2] 770001 filter and 760175 HEPA)
1900094 HEPA2 VOC Filter Replacement Kit (760200 HEPA2, 190985 access port filter, 770001 filter)
224175 Shelf
190868 Decontamination kit with HEPA filter
190869 Decontamination kit without HEPA filter
130077 Stopper with 3/8” hole
290090 Thermal conductivity type CO2 sensor
190885 Infrared type CO2 sensor w/ auto zero
250087 CO2 valve with fittings
290154 RH sensor assembly (RH display option)
190883 Sample port filter assembly
190661 IR sensor filter
190985 Filtered air exchange assembly
230153 6A, DPDT circuit breaker switch (power)
400201 40W Switcher kit
420096 130VA transformer, int’l, 12/24V S
194021 34 position control to display ribbon cable
420097 43VA transformer (230VAC units only)
360213 Pressure switch (Gas Guard option)
250121 Gas valve (Gas Guard option)
190512 4-20mA output board
190543 0-5V output board
190544 0-1V output board
To Next Page
Loading...
