On units that have the RS485 option, direct communication with the
Model 1535 alarm system can be established. Each piece of equipment
connected to the 1535 must have a unique address. An address of 0-24 can
be entered for the incubator. A setting of 0 is an invalid address that the
1535 will ignore. The factory setting for the RS485 address is 0.
1. Press the Mode key until the Config indicator lights.
2. Press the right arrow until RS485 XX is displayed in the message
center.
3. Press up/down arrow to move the RS485 address.
4. Press Enter to save the RS485 address.
5. Press the Mode key to return to Run mode or right/left to go to
next/previous parameter.
3-8 Model 310 Series DH Incubator Thermo Scientific
Section 3
Configuration
Communications
Address for RS485
To Next Page
Loading...
