Important Read this instruction manual. Failure to read, understand and follow the instructions in this manual
may result in damage to the unit, injury to operating personnel, and poor equipment performance.
s
Warning If this unit is not used in the manner specified in this operating manual, the protection provided by
the equipment design may be impaired. s
Intended Use: The 310 Series Direct Heat Incubators are designed to maintain an optimal environment for
the incubation of tissue and cell samples. These models are designed to maintain temperature and Carbon
Dioxide levels as set by the operator as well as monitoring chamber relative humidity. CO2 is controlled using
either a thermo conductivity cell, or an infra-red sensor. T
The incubators are approved for general purpose use as a Microbiological Incubator (21 CFR 866.2540) and
are also approved use in assisted reproductive procedures for the incubation of ova and embryos (21 CFR
884.6120).
Non-intended Use:
The 310 Series Direct Heat Incubators are not intended for use where electrical or physical
contact with the patient is established.
These incubators are not intended to be operated in potentially explosive environments and are not intended
for use with flammable materials.
Caution All internal adjustments and maintenance must be performed by qualified service personnel.
s
Material in this manual is for information purposes only. The contents and the product it describes are subject
to change without notice. Thermo Fisher Scientific makes no representations or warranties with respect to this
manual. In no event shall Thermo be held liable for any damages, direct or incidental, arising out of or related
to the use of this manual.
©2003 Thermo Fisher Scientific. All rights reserved.
To Next Page
Loading...
