4-4 Model 310 Series DH Incubator Thermo Scientific
PREVENTIVE MAINTENANCE
Incubators
Your equipment has been thoroughly tested and calibrated before shipment. Regular preventive maintenance is important to keep your unit
functioning properly. The operator should perform routine cleaning and maintenance on a regular basis. For maximum performance and
efficiency, it is recommended the unit be checked and calibrated periodically by a qualified service technician.
The following is a condensed list of preventive maintenance requirements. See the specified section of the operating manual for further
details.
Thermo Fisher Scientific has qualified service technicians, using NIST traceable instruments, available in many areas. For more information
on Preventive Maintenance or Extended Warranties, please contact Technical Services.
Cleaning and calibration adjustment intervals are dependent upon use, environmental conditions and accuracy required.
Tips for all incubators:
Do NOT use bleach or any disinfectant that has high chloros
Use sterile
, distilled or demineralized water.
Avoid spraying cleaner on the CO
2
sensor.
Do not use powdered gloves for tissue cultures.
To Next Page
Loading...
