1. Plug the incubator line cord into one of the receptacles on the back of
the UPS. Then plug the UPS line cord into a suitable wall outlet.
2. Turn the UPS power switch on.
Use the line cord supplied with the incubator to connect the UPS to a
suitable wall outlet, and the UPS coupler to connect the incubator to the
UPS.
Warning The Uninterruptible Power Supply contains potentially
hazardous voltages even when not connected to line voltage.
Do not attempt to disassemble UPS as it contains no user-serviceable parts.
Repairs must be performed by factory trained service personnel.
s
6-8 Model 310 Series DH Incubator Thermo Scientific
Section 6
Factory Options
Connecting UPS
P/N 270078, 115V, 50/60Hz
Connecting UPS
P/N 270082, 230V, 50/60Hz
To Next Page
Loading...
