THOMSON MEC 310#GENSET CONTROLLER OPTION J-CANBUS J1939 User Manual

MEC 310 GENSET CONTROLLER -
Option J – CANbus J1939
PM077 R1 09/08/20 Page 6 THOMSON TECHNOLOGY
J1939 measurement table
This is the common J1939 measurement overview showing which measurements are available.
Note that not all measurements are supported by the individual engines; please refer to the specific
engine description.
The table shows which values can be displayed in the view screens.
The display values corresponding to the engine communication have a description beginning with
‘EIC’.
Error messages
The following error messages can occur:
Message Description
Engine I. value N.A. The view is not selectable for the present engine type.
Value selected error The value cannot be read due to sensor error, sub-system or
module error.
‘N.A.’ The value is not supported by the engine, or due to
communication error.
For information about
the menu structure, please see the Installation and
Operation Manual.

THOMSON MEC 310#GENSET CONTROLLER OPTION J-CANBUS J1939 Specifications

General

Brand	THOMSON
Model	MEC 310#GENSET CONTROLLER OPTION J-CANBUS J1939
Category	Controller
Language	English