THOMSON MEC 310#GENSET CONTROLLER OPTION J-CANBUS J1939 - MTU ADEC CANopen Details; Displayed Values and Alarms

MEC 310 GENSET CONTROLLER -
Option J – CANbus J1939
PM077 R1 09/08/20 Page 23 THOMSON TECHNOLOGY
MTU ADEC (CANopen)
Display readings
Object
EIC speed
EIC coolant temp.
EIC oil pressure
EIC faults
EIC oil temp.
EIC fuel temp.
EIC Coolant level
EIC charge air pressure
EIC charge air temp.
(or EIC intake manifold 1 temp.)
EIC air inlet press.
EIC running hours
EIC ECU power supp.
EIC oil level
EIC after cooler water inlet temp.
EIC atmospheric press.
EIC ambient air temp.
EIC exch. temp. A
EIC exch. temp. B
EIC temp. winding 1
EIC temp. winding 2
EIC temp. winding 3
EIC turbo 1 outlet temp.
EIC engine intercooler temp.
The MTU ADEC is not a part of the J1939, therefore the reading of values, al
arms
and shutdowns are different.
The Modbus addresses are read only (function code 04h), and are only available
if option M Modbus RTU is implemented.