THOMSON MEC 310#GENSET CONTROLLER OPTION J-CANBUS J1939 - John Deere JDEC J1939 Details; Warnings, Shutdowns, and Control

MEC 310 GENSET CONTROLLER -
Option J – CANbus J1939
PM077 R1 09/08/20 Page 22 THOMSON TECHNOLOGY
John Deere JDEC (J1939)
Warnings and shutdowns
J1939 codes
Warning/shutdown list
SPN
FMI
warning
FMI
shutdown
Low oil pressure 100 18 1
Intake manifold 105 16 -
Coolant temperature 110 16 0
Fuel injection pump 1076 10 6
Fuel temperature 174 - 16
ECU failure 2000 - 6
EIC yellow lamp - X -
EIC red lamp - - X
Write commands to engine controller
•
Engine controls
All the write commands to the engine controller (ex: speed, start/stop, etc.) are enabled in
setting 7563 (EIC Controls).
•
Engine speed
CANbus ID for speed control: 0x0c000000. J1939 TSC1.
FMI indication ‘ – ‘ means that the alarm in question is not supported.
The speed regulation is enabled in setting 2781 (Reg. output) and
7563 (EIC
Controls).