THOMSON MEC 310#GENSET CONTROLLER OPTION J-CANBUS J1939 User Manual

MEC 310 GENSET CONTROLLER -
Option J – CANbus J1939
PM077 R1 09/08/20 Page 4 THOMSON TECHNOLOGY
3. Functional description
This communication extracts information from the Electronic Control Module (ECM) of an engine
equipped with an ECM module with CANbus interface. The values can be used as display values,
alarms/shutdown alarms and values to be transmitted through Modbus.
Engine types
Data can be transmitted between the MEC 310 units and the following engine controllers/types:
Engine Manufacturer Engine Controller/Type Comment
Caterpillar ADEM III and A4/C4.4, C6.6, C9, C15,
C18, C32
Rx/Tx
Cummins CM570, CM850/QSL, QSB5 & 7,
QSM11, QSK19, 50 & 60
Rx/Tx
Detroit Diesel DDEC III and IV/Series 50, 60 & 2000 Rx/Tx
Deutz EMR 2 (EMR)/912, 913, 914 and L2011 Rx/Tx
- General J1939 Rx/Tx
Iveco EDC7 (Bosch MS6.2)/Series NEF,
CURSOR and VECTOR 8
Rx/Tx
John Deere JDEC/PowerTech M, E and Plus Rx/Tx
MTU MDEC, module M.302 or M.303/Series
2000 and 4000
Rx
MTU MDEC, module M.201 or M.304/Series
2000 and 4000
Rx
Select M.303
MTU ADEC/Series 2000 and 4000 Rx/Tx
Perkins Series 1100, 1300, 2300 and 2800 Rx/Tx
Scania EMS Rx
Scania EMS S6 (KWP2000)/Dx9x, Dx12x,
Dx16x
Rx/Tx
Volvo Penta EDC4 Rx
Select EMR 2
Volvo Penta EMS Rx
Volvo Penta EMS 2 and EDCIII/D6, D7, D9, D12 and
D16 (GE and AUX variants only)
Rx/Tx
The engine type is selected in menu 7561.
For support of controller/engine types not listed, please contact Thomson
Technology.
Rx/Tx: Please go to the section ‘Specific engine type descrip
tions’ for details of
data read and write.

THOMSON MEC 310#GENSET CONTROLLER OPTION J-CANBUS J1939 Specifications

General

Brand	THOMSON
Model	MEC 310#GENSET CONTROLLER OPTION J-CANBUS J1939
Category	Controller
Language	English