THOMSON MEC 310#GENSET CONTROLLER OPTION J-CANBUS J1939 User Manual

MEC 310 GENSET CONTROLLER -
Option J – CANbus J1939
PM077 R1 09/08/20 Page 11 THOMSON TECHNOLOGY
Control commands sent to the engine
Engine types with the possibility to send commands to the ECM via the CANbus communication
line:
Engine type
Command
Detroit Diesel DDEC
John Deere JDEC
Caterpillar
Perkins
Cummins
Generic J1939
Deutz EMR
Iveco
MTU MDEC
MTU ADEC
Scania EMS
Scania EMS S6
Volvo Penta
Volvo Penta EMS 2
Preheat - - - - - - - X - - - - - X
Start / Stop - - - - - - - X - X - X - X
Engine speed X X X X X X X X - X - X - X
Nominal frequency - - - - X - - - X - X - X
Governor gain - - - - X - - - - - - - - -
Idle speed - - - - - - - - - - - X - X
Droop - - - - X - - - - - - X - X
Shutdown override - - - - X - - - - - - X - -
For engine types not mentioned, CANbus control is not supported. In these
cases start/stop etc. must be send to the controller using hardwired
connections.
The menu number 7563 has to be used for enabling or disabling the
transmission of all the MEC 310 unit EIC control frames listed in the above table.
When the droop command is not available for an engine communication type,
the droop emulated function can be selected by using M-
logic. In this case, it will
be the MEC 310 unit that will operate the droop function. See the M-
logic
documentation.
When the droop command is available for an engine communication type, the
droop function must be enabled by using M-logic only. See the M-
logic
documentation.

THOMSON MEC 310#GENSET CONTROLLER OPTION J-CANBUS J1939 Specifications

General

Brand	THOMSON
Model	MEC 310#GENSET CONTROLLER OPTION J-CANBUS J1939
Category	Controller
Language	English