MEC 310 GENSET CONTROLLER
PM075 REV 2 09/08/20 Page 34 THOMSON TECHNOLOGY
Remember to activate the function by marking the Enable
tick box.
If the alarm is only to be active when the gen-set is
running, the inhibit settings must be used. If etc “Not run
status” is ticked in the inhibit settings, it means that the
alarm is inhibited until the running feedback is present,
when the Run status timer has not yet expired.
If the High Alarm is set, the alarm will be registered upon a
closing contact. If the High Alarm is not set, the alarm will
be registered upon an
[0]
opening contact.
To Next Page
Loading...
