THOMSON MEC 310#GENSET CONTROLLER User Manual

MEC 310 GENSET CONTROLLER
PM075 REV 2 09/08/20 Page 36 THOMSON TECHNOLOGY
Double-click on relay 45 and relay 47 to open up the settings window. From the dropdown list
found in the Setpoint section select ‘Limit function’.
3. Under the M-Logic tab, the user will need to setup a Logic rung for Common Warning and
a Logic rung for Common Shutdown. Have each Logic rung tied to the appropriate output
relay.
In the TPS300 Software, click on the
Parameters tab found on the left hand side.
Remember to write the settings to the unit.

THOMSON MEC 310#GENSET CONTROLLER Specifications

General

Brand	THOMSON
Model	MEC 310#GENSET CONTROLLER
Category	Controller
Language	English