© 2016 Thorlabs Scientific Imaging150
DCx Camera Functional Description and SDK Manual
IS_CONFIG_OPEN_MP_CMD_GET_ENABLE_DEFAULT
Returns the default setting for OpenMP support.
Additional information
pParam: Pointer to a UINT bitmask. The status
flags from CONFIGURATION_SEL are returned in
the bitmask.
nSizeOfParam: 4
IS_CONFIG_INITIAL_PARAMETERSET_CMD_SET
Sets the parameter set to read and apply from the
camera EEPROM when the camera is opened.
Additional information
pParam: Pointer to a UINT variable,
IS_CONFIG_INITIAL_PARAMETERSET_NONE
IS_CONFIG_INITIAL_PARAMETERSET_1
IS_CONFIG_INITIAL_PARAMETERSET_2
nSizeOfParam: 4
IS_CONFIG_INITIAL_PARAMETERSET_CMD_GET
Returns which parameter set will be read and
applied from the camera EEPROM when the
camera is opened.
Additional information
pParam: Pointer to a UINT variable,
IS_CONFIG_INITIAL_PARAMETERSET_NONE
IS_CONFIG_INITIAL_PARAMETERSET_1
IS_CONFIG_INITIAL_PARAMETERSET_2
nSizeOfParam: 4
Pointer to a function parameter, whose function
depends on nCommand.
Size (in bytes) of the memory area to which
pParam refers.
Contents of the CONFIGURATION_CAPS Structure
IS_CONFIG_CPU_IDLE_STATES_CAP_SUPPORT
ED
Function parameters for setting the
processor operating states are supported.
IS_CONFIG_OPEN_MP_CAP_SUPPORTED
Function parameters to configure OpenMP
are supported.
IS_CONFIG_INITIAL_PARAMETERSET_CAP_SU
PPORTED
Function parameters to load camera
parameters during initialization are
supported.
Contents of the CONFIGURATION_SEL Structure
IS_CONFIG_CPU_IDLE_STATES_BIT_AC_VALU
E
Set/recover processor operating states for
power supply unit operation
IS_CONFIG_CPU_IDLE_STATES_BIT_DC_VALU
Set/recover processor operating states for