© 2016 Thorlabs Scientific Imaging
2 Camera Basics
19
* Flash function optional. See also Digital in-/output (trigger/flash).
Note
In freerun mode the flash function starts with the second image as the setting of the flash timing
depends on the finish of the first image. If you change the flash timing during operation, the freerun
mode will restart. Therefore the first image after the change is black.
Single frame mode (snap mode)
The next image exposed by the sensor will be transferred. In this mode, flash is not making sense
(only manually).
See also:
Basics: Shutter methods
Basics: Trigger mode
Basics: Applying new parameters
Programming:
Capture modes
To Next Page
Loading...
Need help?
General
