THORLABS DCU223 SERIES Description And Sdk Manual

© 2016 Thorlabs Scientific Imaging
4 Programming (SDK)
299
4.3.66 is_IsVideoFinish
USB 2.0
USB 3.0
USB 2.0
USB 3.0
Syntax
INT is_IsVideoFinish (HIDS hCam, INT* pbo)
Description
Using is_IsVideoFinish(), you can check whether an image has been captured and stored
completely in the image memory. This function is helpful if the is_FreezeVideo() function was
called with the IS_DONT_WAIT parameter.
By setting the *pbo==IS_CAPTURE_STATUS parameter before calling is_IsVideoFinish(), you can
also check whether a transfer or post-processing error occurred.
Input parameters
hCam
Camera handle
pbo
By setting *pbo != IS_CAPTURE_STATUS before calling the function,
pbo contains the following digitizing status:
IS_VIDEO_NOT_FINISH = Digitizing of the image is not completed
yet.
IS_VIDEO_FINISH = Digitizing of the image is completed.
By setting *pbo == IS_CAPTURE_STATUS before calling the function,
pbo contains the following digitizing status:
IS_VIDEO_NOT_FINISH = Digitizing of the image is not completed
yet.
IS_VIDEO_FINISH = Digitizing of the image is completed.
IS_CAPTURE_STATUS = Transfer error or conversion problem (e.g.
destination memory is invalid)
The parameter IS_CAPTURE_STATUS replaces the previous
parameter IS_TRANSFER_FAILED.
The parameter IS_TRANSFER_FAILED was moved into the new
header file uc480_deprecated.h, which contains all obsolete
function definitions and constants. If necessary the header file
uc480_deprecated.h can be included in addition to the header file
uc480.h.
Return values
IS_INVALID_CAMERA_HANDLE
Invalid camera handle
IS_INVALID_PARAMETER
One of the submitted parameters is outside the
valid range or is not supported for this sensor or
is not available in this mode.
IS_NO_SUCCESS
General error message
IS_SUCCESS
Function executed successfully
Related functions
is_FreezeVideo()

THORLABS DCU223 SERIES Specifications

General

Brand	THORLABS
Model	DCU223 SERIES
Category	Security Camera
Language	English