THORLABS DCU223 SERIES User Manual

© 2013 Thorlabs GmbH
4 Programming (SDK)
187
Example 4
UINT nEnabled = 0;
INT nRet = is_Configuration(IS_CONFIG_OPEN_MP_CMD_GET_ENABLE, (void*)&nEnabled, sizeof(nEnabled));
if (nRet == IS_SUCCESS)
{
if (nEnabled == IS_CONFIG_OPEN_MP_ENABLE)
{
// OpenMP enabled
}
}
nEnabled = 0;
nRet = is_Configuration(IS_CONFIG_OPEN_MP_CMD_GET_ENABLE_DEFAULT, (void*)&nEnabled, sizeof(nEnabled));
if (nRet == IS_SUCCESS)
{
nRet = is_Configuration(IS_CONFIG_OPEN_MP_CMD_SET_ENABLE, (void*)&nEnabled, sizeof(nEnabled));
if (nRet == IS_SUCCESS)
{
// Default value set
}
}
Example 5
UINT nNumber = 0;
INT nRet = is_Configuration(IS_CONFIG_INITIAL_PARAMETERSET_CMD_GET, (void*)&nNumber, sizeof(nNumber));
if (nRet == IS_SUCCESS)
{
if (nNumber == IS_CONFIG_INITIAL_PARAMETERSET_NONE)
{
// No parameter set specified
}
else if (nNumber == IS_CONFIG_INITIAL_PARAMETERSET_1)
{
// Parameter set 1
}
else if (nNumber == IS_CONFIG_INITIAL_PARAMETERSET_2)
{
// Parameter set 2
}
}
nNumber = IS_CONFIG_INITIAL_PARAMETERSET_2;
is_Configuration(IS_CONFIG_INITIAL_PARAMETERSET_CMD_SET, (void*)&nNumber, sizeof(nNumber));
if (nRet == IS_SUCCESS)
{
// Set to parameter set 2
}

THORLABS DCU223 SERIES Specifications

General

Brand	THORLABS
Model	DCU223 SERIES
Category	Security Camera
Language	English