THORLABS PM100D - LabVIEW SCPI Example

6.4 PM100D SCPI Commands
6.4.2.3.6 INPut subsystem commands
Command Description
INPut
[:PDIode]
:FILTer
[:LPASs]
[STATe] {OFF|0|ON|1}
[STATe]?
Sets the bandwidth of the photodiode input stage
Queries the bandwidth of the photodiode inut stage
:THERmopile
:ACCelerator
[STATe] {OFF|0|ON|1}
[STATe]?
:AUTO {OFF|0|ON|1}
?
:TAU {MINimum|
MAXimum|DEFault|
<numeric_value>[s]}
:TAU? [{MINimum|
MAXimum|DEFault}]
Sets the thermopile accelerator state
Queries the thermopile accelerator state
Sets the thermopile accelerator to auto mode
Queries thermopile accelerator auto mode
Sets thermopile time constant 0-63% in s
Queries the thermopile time constant in s
:ADAPter
[:TYPE] {PHOTodiode|
THERmal|PYRo}
[:TYPE]?
Sets default sensor adapter type
Queries default sensor adapter type
56