THORLABS PM100D User Manual

8.2 Certifications and compliances
8.2 Certifications and compliances
Certifications and compliances
Category Standards or description
EC Declaration
of Conformity –
EMC
Meets intent of Directive 89/336/EEC for Electromagnetic Compatibility. Compliance
was demonstrated to the following specifications as listed in the Official Journal of
the European Communities:
EN 61326:1997
+A1:1998 +A2:2001
+A3:2003
Electrical equipment for measurement, control and
laboratory use – EMC requirements:
Immunity: complies with immunity test requirements for
equipment intended for use in industrial locations
1
.
Emission: complies with EN 55011 Class B Limits
1,3
,
IEC 610003-2 and IEC 61000-3-3.
IEC 61000-4-2 Electrostatic Discharge Immunity (Performance criterion C)
IEC 61000-4-3 Radiated RF Electromagnetic Field Immunity (Performance
Criterion A)
5
IEC 61000-4-4 Electrical Fast Transient / Burst Immunity (Perf. Criterion C)
IEC 61000-4-5 Power Line Surge Immunity (Performance Criterion A)
IEC 61000-4-6 Conducted RF Immunity (Performance Criterion A)
IEC 61000-4-8 Power Frequency Magnetic Field Immunity (Perf. Criterion A)
IEC 61000-4-11 Voltage Dips, Short Interruptions and Voltage Variations
Immunity (Performance Criterion A / C
6
)
IEC 61000-3-2 AC Power Line Harmonic Emissions
IEC 61000-3-3 Voltage Fluctuations and Flicker
FCC EMC
Compliance
Emissions comply with the Class B Limits of FCC Code of Federal Regulations 47,
Part 15, Subpart B
1,3
.
EC Declaration
of Conformity -
Low Voltage
Compliance was demonstrated to the following specification as listed in the Official
Journal of the European Communities:
Low Voltage Directive 73/23/EEC, amended by 93/68/EEC
EN 61010-1:2001 Safety requirements for electrical
equipment for measurement, control and
laboratory use.
U.S. Nationally
Recognized
Testing
Laboratory
Listing
UL 61010-1 2
nd
ed. Safety requirements for electrical
equipment for measurement, control, and
laboratory use.
ISA-82:02.01 Safety requirements for electrical
equipment for measurement, control, and
laboratory use.
Canadian
Certification
CAN/CSA C22.2 No. 61010-1-04 Safety requirements for electrical
equipment for measurement, control, and
laboratory use.
Additional
Compliance
IEC 61010-1:2001 Safety requirements for electrical
equipment for measurement, control, and
laboratory use.
Equipment Type Test and measuring
Safety Class Class I equipment (as defined in IEC 60950-1:2001)
1
Compliance demonstrated using high-quality shielded interface cables shorter than 3 meters.
3
Emissions, which exceed the levels required by these standards, may occur when this equipment is
connected to a test object.
5
MOD IN port capped at IEC 61000-4-3 test.
6
Performance Criterion C was reached at additional test levels according to EN 61326-1:2006 table 2
65

THORLABS PM100D Specifications

General

Data Logging	Yes
Storage Temperature Range	-20 °C to 70 °C
Power Accuracy	±0.5% of reading
Interface	USB
Power Supply	USB or AC Adapter
Display Update Rate	10 Hz
Detector Type	Photodiode or Thermopile (Sensor Dependent)