TOHO TTM-i4N - Event 2 Output Parameter Mode

18
 6.3.8 Event 2 Output Parameter Mode
PV
SV
SET5

1. Setting Mode Selection Screen
※12 ※13
AL2

↓M Key
PV
SV
A2F1

2. Event 2 Function Setting 1
  ※12
000

↓M Key
PV
SV
A2H

3. EV2 alarm upper limit setting
※12 ※14 ※15
0

↓M Key
PV
SV
A2L

4. EV2 alarm lower limit setting
※12 ※14 ※16
0

↓M Key
PV
SV
A2C

5. EV2 alarm sensitivity setting
※12 ※14
0

↓M Key
PV
SV
A2T

6. EV2 alarm delay timer setting
※12 ※17
0

↓M Key
PV
SV
A2F2

7. EV2 alarm function 2 setting
  ※12
000

↓M Key
PV
SV
A2F3

8. EV2 alarm function 3 setting
  ※12
00

↓M Key
PV
SV
A2P

9. EV2 alarm polarity setting
  ※12
0

↓M Key
      Back to 1.
  ※12 … This will not be displayed when the model of B option is not specified.
  ※13 … This will not be displayed when the output type of Output 2 is other than “Event 2 Output.”
  ※14 … This will not be displayed when Event 2 function is set to “OFF.”
  ※15 … This will not be displayed when Event 2 function will not be used at the maximum limit.
  ※16 … This will not be displayed when Event 2 function will not be used at the minimum limit.
  ※17 … This will not be displayed when Event 2 functions 1 and 2 are set to “OFF.”