Topcon BM-7A - Numerical Value Setting

3. Various Settings
43
3.1.3 Numerical Value Setting
Numerical values are set when setting the luminance factor of the white board or the like.
The procedure for setting numerical values in the function mode is the same for all setting items.
Here, an example of setting the luminance factor of the white board is used to explain the
procedure for setting numerical values in the function mode.
White board luminance factor setting screen
1 Press the [CHANGE] button.
The following screen is displayed.
・ When dip switch 8 is on the WRITE side, this screen is not displayed. In that case,
advance to step 3.
2 Set dip switch 8 to the WRITE side.
A "." is displayed in the area where input is possible.
3 Press the [ROTATION] button and select the value to input.
Each time the button is pressed, the display changes as shown below.
．→ ０ → １ → ２ → ３ → ４ → ５ → ６ → ７ → ８ → ９ → ＋ → － → Ｅ → ．……
・ When entering a numerical value having more than one digit, press the [SHIFT] button
to move to the next digit, and repeat step 3 to select the value to be input.
Memo
Ａｔｔｅｎｔｉｏｎ ！！
Ｐｌｅａｓｅ ｓｅｔ
ｔｈｅ ＰＲＯＴＥＣＴ／ＷＲＩＴＥ ＳＷ
ｔｏ ｔｈｅ ＷＲＩＴＥ ｓｉｄｅ．
＊ Ｗｈｉｔｅ ｂｏａｒｄ ＊
Ｌｕｍｉｎａｎｃｅ ｆａｃｔｏｒ
１
＊ Ｗｈｉｔｅ ｂｏａｒｄ ＊
Ｌｕｍｉｎａｎｃｅ ｆａｃｔｏｒ
．
＊ Ｗｈｉｔｅ ｂｏａｒｄ ＊
Ｌｕｍｉｎａｎｃｅ ｆａｃｔｏｒ
１００．０ ％
Memo