Topcon BM-7A - Measurement Value Display Mode

2. Measurement Operation
37
2.6 Measurement Value Display Mode
When the display is in the HOLD state ([HOLD] of the RUN/HOLD switch is blinking), it is
possible to change the measurement value display mode by pressing the MODE switch.
Each time the switch is pressed, the display changes as shown below.
― Light Source Color ―
Chromaticity xy Luminance L
Chromaticity u ’v’ Luminance L
Tristimulus value XYZ
Color temperature Tc Deviation duv Luminance L
Ｆ２．０ ＡＢＳ Ｋ００ Ｇ００－０
ｘ＝ ０．２９６３
ｙ＝ ０．３６８８
Ｌ＝ １．４１１Ｅ＋０２ ｃｄ／ｍ＾２
Ｆ２．０ ＡＢＳ Ｋ００ Ｇ００－０
ｕ’＝ ０．１７３４
ｖ’＝ ０．４８５７
Ｌ＝ １．４１１Ｅ＋０２ ｃｄ／ｍ＾２
Ｆ２．０ ＡＢＳ Ｋ００ Ｇ００－０
Ｘ＝ １．１３４Ｅ＋０２
Ｙ＝ １．４１１Ｅ＋０２ ｃｄ／ｍ＾２
Ｚ＝ １．２８２Ｅ＋０２
Ｆ２．０ ＡＢＳ Ｋ００ Ｇ００－０
Ｔｃ ＝ ６９７６ Ｋ
ｄｕｖ＝ ０．０５５
Ｌ＝ １．４１１Ｅ＋０２ ｃｄ／ｍ＾２