Topcon BM-7A - CA Command; TF Command; TS Command; MA Command

4. Communication With a PC
63
4.2.2 CA Command
The Zero-adjustment is performed.
PC Command BM-7A
CA + (Cr･Lf)
OK + (Cr･Lf)
END + (Cr･Lf)
4.2.3 TF Command
The response speed of the photo-receiver circuit of the instrument is changed to the FAST mode.
PC Command BM-7A
TF + (Cr･Lf)
OK + (Cr･Lf)
4.2.4 TS Command
The response speed of the photo-receiver circuit of the instrument is changed to the SLOW
mode.
PC Command BM-7A
TS + (Cr･Lf)
OK + (Cr･Lf)
4.2.5 MA Command
The measurement range of the instrument is changed to the AUTO range.
PC Command BM-7A
MA + (Cr･Lf)
OK + (Cr･Lf)