Topcon BM-7A - Clearing the Correction Factor

3. Various Settings
51
3.6.3 Clearing the Correction Factor
The following screen is displayed.
Press the [ROTATION] button, and select the process to perform (indicated by "*").
ALL CLEAR : Selected when clearing all correction factors.
SELECT CLEAR : Selected when clearing individual correction factors.
When "ALL CLEAR" is Selected
YES : Clears all registered correction factors.
BACK : Returns to the previous screen.
When "SELECT CLEAR" is Selected
[CHANGE] : Clears the displayed data.
[ROTATION] : Displays the data for the next number.
[SHIFT] : Each time the button is pressed, the display changes as shown below.
Correction factor → Reference data → Correction factor data …
[ENTER] : Returns to the previous screen.
Request
・ When the reference data is cleared, correction factor data and sample data of
the same number are also cleared.
ＣＬ１ ＫＸ＝ １．０００Ｅ+００
ＳＥＴ ＫＹ＝ １．０００Ｅ+００
ＫＺ＝ １．０００Ｅ+００
Ｃ＝ＤＥＬ Ｒ＝ＮＥＸＴ Ｓ＝ＰＡＧＥ
ＦＡＣＴＯＲ ＣＬＥＡＲ
ＡＬＬ ＦＡＣＴＯＲ ＣＬＥＡＲ
ＹＥＳ
＊ＢＡＣＫ
ＦＡＣＴＯＲ ＣＬＥＡＲ
ＡＬＬ ＣＬＥＡＲ
ＳＥＬＥＣＴ ＣＬＥＡＲ
＊ＢＡＣＫ