3. Various Settings
50
3
Set the sample data and press the RUN/HOLD switch.
After measurement, the measurement result is displayed for about 10 seconds, then, the
correction factor is calculated using the input reference data and measured sample data is
displayed.
[ROTATION] : The correction factor for the next number is displayed.
[SHIFT] : Each time the button is pressed, the display changes as shown below.
Reference data → Sample data → Correction factor data → …
[ENTER] : Returns to the previous screen.
Ｋ０１ ＫＸ＝ ５．６５４Ｅ－０１
ＳＥＴ ＫＹ＝ ９．２３９Ｅ－０１
ＫＺ＝ ７．４５４Ｅ+００
Ｒ＝ＮＥＸＴ Ｓ＝ＰＡＧＥ
To Next Page
Loading...
