Topcon BM-7A - Communication Format; Average Measure

3. Various Settings
58
3.12 Communication Format
The communication format with the PC is displayed.
Display Method
☞
「3.1.2 Data/Setting Item Display」
The communication format consists of BM-7A and BM-7FAST.
・ BM-7FAST is a communication format for the purpose of using communication software for
old model BM-7 and BM-7fast. The commands for BM-7A is increased than the BM-7 and
BM-7fast, so when creating new communication software, the BM-7A mode is recommended.
The procedure for selection the mode is as described below.
1 Press the [CHANGE] button.
2 Press the [ROTATION] button and select the setting contents.
Each time the button is pressed, the display will change as shown below.
BM-7A → BM-7FAST → BM-7A ……
3 After selection is finished, press the [ENTER] button.
3.13 Average Measure
The average measurement can be set.
Display Method
☞
「3.1.2 Data/Setting Item Display」
When measuring varying-luminance light source, use this function. Measurement result in
Average measure is the average value of 5 times measurement and, measurement interval
is about 1 second.
1 Press the [CHANGE] button.
2 Press the [ROTATION] button and select the setting contents.
Each time the button is pressed, the display will change as shown below.
Single → Average → Single ……
3 After selection is finished, press the [ENTER] button.
Memo
＊ ＤＡＴＡ ＦＯＲＭＡＴ ＊
ＢＭ－７Ａ
＊ Ａｖｅｒａｇｅ Ｍｅａｓｕｒｅ ＊
Ｓｉｎｇｌｅ