20
PREPARATIONS
PREPARATIONS
INSTALLATION
1 Use the base stopper to fix the main body.
2 Firmly hold the instrument at the position shown below and place it on the automatic instrument
table. For the adjustable instrument table, see "OPTIONAL ACCESSORIES" on page 74.
3 After installation, turn the base stopper down. The main body can be moved.
CONNECTING POWER CABLE
1 Make sure the POWER switch of the instrument is OFF.
CAUTION
• When moving the instrument, two people should lift from the bot-
tom of the device.
One person lifting the device may cause harm to his back or
injury by falling parts. Also, holding areas other than the bottom
and holding the External I/O terminal cover may cause injury, as
well as damage to the instrument.
• To prevent damage and injuries, do not install the instrument on
an uneven, unsteady or sloped surface.
• When setting an instrument on an instrument table, pay attention
not to injury the patient's fingers between the instrument and the
table.
WARNING
Be sure to connect the power plug to an AC 3-pin receptacle
equipped with grounding. Connection with receptacle without
grounding may cause fire and electric shock in case of short-
circuiting.
CAUTION
To avoid electric shocks, do not handle the power plug with wet
fingers.
Holding positions Holding the instrument
To Next Page
Loading...
