Topcon CT-800 - Displaying Measurement Values

35
BASIC OPERATIONS
BASIC OPERATIONS
MEASUREMENT
DISPLAYING MEASUREMENT VALUES
With regard to TONO measurement values, data of the latest three measurements are displayed on
the control panel.
Figures only: Measurement was done correctly.
[ ] figures: When the reliability of measurement is low.
ERROR: Measurement was not done correctly.
OVER: When the measurement range is exceeded.
NOTE
• In TONO average value display, low-reliability numerical data with [ ] are
not added to the average value calculation.
However, if all measurement data are numerical data with [ ], the average
value calculation is done using these data.
• For explanation of the messages on the control panel screen, refer to
"MESSAGE LIST" on page 62.
• When data is printed out, the "M" mark is printed on the value measured
in auto shoot mode off.
P
a
tientI
D
PatientID
3
3
3
3
15
15
15
15
15
15
15
15
1
1
TOPCON
T
ARO
U
TOPCONTAROU
14
[15]
16
14
[15]
16
15
17
14
15
17
14
0.499
0.499
0.500
0.500
1
1
1
1
Auto Shoot
Latest data
Data of 2 times ago
Data of 1 time ago