Topcon ISOCAN - Default Chapter; Table of Contents

To Next Page

To Previous Page

ISOCAN / ISOBUS ARTEMIS - SEED DRILL CONTROLLER

1. OVERVIEW 5

1.1 Standard Kits 5

1.2 Drill Configurations and Kits required 5

1.3 Basic ISOCAN Single-motor system Schematic 6

1.4 Basic ISOBUS Single-motor system Schematic 7

1.5 2, 3 and 4-motor systems Schematic 8

1.6 Extension Cable Kit Ref. P/ART2/EXT/4M (option for trailed drills) 8

1.7 Parts List 9

2 MOTOR 12

2.1 Motor 12

2.1.1 Motor rotation ............................................................................................................................................. 13

2.1.2 Motor Connections ...................................................................................................................................... 13

3 MOTOR CONTROL MODULE AND SENSORS 14

3.1 MCM mounting 14

3.2 Power Supply 14

3.3 Motor and MCM 0V connection and Grounding 14

3.4 MCM Control channel setup 16

3.5 Priming Switch 16

3.6 Seed Shaft Confirmation Sensor 17

3.7 Metering unit setup 17

3.8 Hopper Level sensors 18

3.8.1 Hopper level sensor configuration ............................................................................................................... 18

4 ECU AND SENSORS 19

4.1 Fan Speed Sensor 19

4.2 Area Cutout / Lift-Lower / Tramline advance 19

4.2.1 Area cutout / Tramline advance................................................................................................................... 19

4.2.2 Lift-Lower installation ..................................................................................................................................20

4.2.3 Tramline Module Configuration................................................................................................................... 20

4.2.4 Area cutout / Lift-Lower / Tramline advance configuration......................................................................... 21

4.3 Forward Speed Input 21

4.3.1 Satspeed 2.................................................................................................................................................... 21

4.3.2 GPS / ISOBUS................................................................................................................................................ 22

4.4 Tramline Mechanisms 23

4.4.1 Motor-type Tramline mechanisms............................................................................................................... 23

4.4.2 Solenoid-type Tramline mechanisms` .......................................................................................................... 24

5 WIRING 25

5.1 MCM – Expansion Harness and Sensors 25

5.1.1 Setting the MCM ID...................................................................................................................................... 26

5.1.2 Expansion Harness (S/TC/1015540-01) Wiring Table................................................................................... 26

5.2 ISOBUS Artemis ECU (AS1) 27

5.2.1 ISOBUS Artemis ECU (AS1) Wiring Table ...................................................................................................... 28