Toro ProCore 648s - Assembling the Brake Cable; Connecting the Wire Harness

AssemblingtheBrakeCable
1.Routethettingofthebrakecableunderthe
bottomofthehandle-barchannel(Figure6).
g358118
Figure6
1.Handle-barchannel
4.Clevispin
2.Brake-cabletting
5.Hairpin
3.Washer(5/16inch)
2.Assemblethebrake-cablettingontotheclevis
pin,andsecurethettingtothepinwiththe
washerandhairpin.
ConnectingtheWireHarness
1.Routethe6-pinconnectorandthe12-pin
connectorofthemachinewireharnessthrough
thegrommetinthehandle-barchannel(Figure
7).
g358122
Figure7
1.6-pinconnector(machine
wireharness)
2.12-pinconnector(machine
wireharness)
2.Plugthe12-pinconnectorofthemachine
harnessintothe12-socketconnectorofthe
handlebarwireharness(Figure8).
g358121
Figure8
1.12-socketconnector
(handlewireharness)
3.6-pinconnector(machine
wireharness)
2.6-socketconnector
(handlewireharness)
4.12-pinconnector(machine
wireharness)
3.Plugthe6-pinconnectorofthemachineharness
intothe6-socketconnectorofthehandlebar
harness.
4.Insertthepush-inanchorofthemachine
harnessintotheholeinthehandle-barchannel
(Figure9).
13