Toro ProCore 648s - Installing the Handlebar Cover

g358123
Figure9
1.Push-inanchor
3.Guidebracket
2.Handle-barchannel
5.Insertthepush-inanchorofthemachine
harnessintotheholeintheguidebracket.
6.Securethemachineharnesstothehandle-bar
channelwithacabletiethroughtheslotsinthe
channel(Figure10).
g372270
Figure10
1.Slot(handle-barchannel)3.Slot(guidebracket)
2.Cabletie
7.Securethemachineharnesstotheguide
bracketwithacabletiethroughtheslotsinthe
bracket.
InstallingtheHandlebarCover
1.Alignthesmallnotchinthehandlebarcoverwith
thenotchup(Figure11).
g358120
Figure11
1.Thread-formingscrew
(1/4inch)
3.Smallnotch(handle-bar
cover)
2.Handle-barchannel
14