ELECTRICAL
7-7
Toro TITAN 2009-2013 Service Manual
7
Testing
1. Remove the LH control cover (A).
2. Press inward on the locking taps and push the
switch out of the mounting slot.
3. Pull the switch and harness downward, in-between
the frame and deck assembly.
4. Disconnect the harness connection to switch and
remove the switch from the unit.
5. Use a ohm meter to test the switch continuity as
shown below:
View From Back of Switch (Fig. 147)
Parking Brake Circuit
(Fig. 148)
2
3
5
4
Fig. 147 PICT-2012
To Magnito - Spark Kill
To Fuel Solenoid
Fig. 148 PICT-2011
Switch Plunger NOT Depressed:
Pin 2 and 3 – CLOSED, continuity between the pins
Pin 4 and 5 – OPEN, NO continuity between the pins
Switch Plunger Depressed:
Pin 2 and 3 – OPEN, NO continuity between the pins
Pin 4 and 5 – CLOSED, continuity between the pins
To Next Page
Loading...
