Toro titan zx - Seat Support Installation

CHASSIS
3-18
Toro TITAN 2009-2013 Service Manual
3
Fig. 037 PICT-2069
9. Install and sufciently tighten the (2) thread forming
bolts that secure the rear guard tube (C) to the seat
support (E). OR Install the bolts / nuts securing the
rear engine guard to the ROPS frame (F) (Fig. 039).
Fig. 039 PICT-2070
Seat Support Installation
1. Position the Seat Support assembly into the unit
frame.
2. Install the (2) bolts and nuts that secure the seat
support (E) to the frame brackets and torque to
specication – 17 ft-lbs. (23 Nm).
3. Install the fuel tank retaining rod (B) and torque
retaining bolt to specication – 8 ft-lbs. (11 Nm). Be
sure the front rod end is engaged into the control
box assembly (Fig. 037).
4. Install the (2) bolts that secure the hydro expansion
tank (A) to the seat support and torque to
specication – 5 ft-lbs. (7 Nm).
5. Properly route cables / wiring and reinstall cable ties
/ loom clams to secure them to the seat support.
6. Install RH and LH pod / fender as outlined in this
chapter.
7. Connect the battery cables and lower seat.
8. Verify proper function.
C
Fig. 038 PICT-2066
B
C
E
A
B