Toro titan zx - Leveling Mower Deck (48, 54, 60 Inch)

MOWER DECK
6-21
Toro TITAN 2009-2013 Service Manual
6
5. Measure from the tip of the blade to the level
surface. The variance should be no more than 1/8”
(3mm) (Fig. 121).
Leveling Mower Deck - 48, 54, 60 Inch
Deck
Check to ensure the mower deck is level any time you
install the mower or when you see an uneven cut.
The mower deck must be checked for bent blades
prior to leveling; any bent blades must be removed
and replaced. Refer to the Checking for Bent Blades
procedure before continuing.
The mower deck must be leveled side-to-side rst then
the front to rear slope can be adjusted.
Requirements:
• The machine must be on a level surface.
• All four tires must be properly inated.
Checking Side-to-Side Level
The mower blades must be level from side to side.
Check the side-to-side level any time you install the
mower or when you see an uneven cut.
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers outward to the
neutral lock position, stop the engine, remove the
key, set the parking brake and wait for all moving
parts to stop before leaving the operating position.
3. Carefully rotate the blades side to side.
Fig. 121 g. 40 G009680
A. Blade, in position for measuring
B. Level surface
C. Measured distance between blade & surface (A)
A
B
C
A blade that is bent or damaged could break apart
and could seriously injure or kill you or bystanders.
• Always replace bent or damaged blade with a
new blade
• Never le or create sharp notches in the edges
or surfaces of blade
a. If the difference between A and B is greater than
1/8” (3mm) replace the blade with a new blade as
outlined in this chapter.
• Recheck, starting at step 1.
Note: If a bent blade is replaced with a new one and
the dimension obtained continues to exceed
1/8” (3mm), the blade spindle shaft could be
bent.
b. If the variance is within constraints, move to the next
blade.
Repeat this procedure on each blade.
!