HYDROSTATIC DRIVE SYSTEM
5-4
Toro TITAN 2009-2013 Service Manual
5
5. Release the parking brake and observe rear tire
movement. If the tire is creeping in either forward or
reverse, a neutral adjustment is required.
Note: A slight amount of reverse creep is
acceptable.
(Fig. 063)
Fig. 062 PICT-6459a
3. Start the engine and run at full RPM.
4. Verify the motion control handles are in the outward
neutral position.
Fig. 063 PICT-6486a
6. Turn engine off.
7. Remove the fender / pod assembly / control panel of
the side that needs neutral adjustment as shown in
chapter 3.
(Fig. 064)
Fig. 064 PICT-6483
Neutral Adjustment
Note: Do not make neutral adjustments on cold
hydrostatic drive systems. Safely warm the
drive system before making adjustments.
1. Safely raise and support unit so rear wheels are off
the ground.
2. Unplug the seat switch and install a jumper wire
across the harness terminals.
Note: Jumping the seat switch is for testing /
adjustment procedures only.
(Fig. 062)
To Next Page
Loading...
