HYDROSTATIC DRIVE SYSTEM
5-12
Toro TITAN 2009-2013 Service Manual
5
Transaxle Installation
1. Position the hydro assembly up into the unit frame
and align mounting points.
2. Apply Loctite
®
242 to the (2) hydro center support
bolts.
3. Loosely install ALL hydro mounting spacers, fast-
eners and center support bolts. Do not fully tighten
at this time.
4. Torque hydro mounting fasteners in sequence to
specication and shown:
1st – Apply Loctite 242 to the hydro center support
bolts. Torque bolts to specication – 17 ft-lbs. (23
Nm) (Fig. 084).
Fig. 082 PICT-2050
14. Remove the (1) rear hydro mounting fastener (Fig.
083).
Fig. 083 PICT-2051
Fig. 084 PICT-2048
13. Remove the (1) front hydro mount fastener (Fig.
082).
15. Lower the hydro assembly then remove it from the
frame.
To Next Page
Loading...
