Toro titan zx - Fuel Tank Service; Fuel Tank Removal

CHASSIS
3-7
Toro TITAN 2009-2013 Service Manual
3
Fuel Tank Service
Fuel Tank Removal
1. Raise seat and disconnect battery terminals.
2. Remove LH pod / fender as shown in this chapter.
3. Remove the (2) bolts that secure the hydro
expansion tank (A) to the seat support. Move the
tank rearward for fuel tank removal clearance.
4. Remove the (1) fastener securing the fuel tank
retaining rod (B) and remove it from the chassis.
5. Remove the (2) thread-forming bolts that secure
the rear guard tube (C) to the seat support (E). OR
Remove the bolts / nuts securing the rear engine
guard to the ROPS frame (D).
(Fig. 011)
6. Remove the (2) bolts and nuts that secure the seat
support (E) to the frame brackets.
7. Note the location of and remove any cable ties /
loom clamps that secure wiring / cables to the seat
support bar (E).
8. Remove the seat support bar from the frame.
9. Disconnect and properly secure the fuel / vent line(s)
from the top of the fuel tank assembly.
10. The fuel tank is now loose and can be removed by
from the unit frame (Fig. 012).
Fig. 011 PICT-2070
Fig. 012 PICT-2066
B
C
E
A
D
C
E