Toro titan zx - Motion Control Assembly

CHASSIS
3-15
Toro TITAN 2009-2013 Service Manual
3
Motion Control Assembly
1. Install the activator arm assembly (F) into the control
box and torque the pivot bolt (G) to specication –
30 ft-lbs. (40 Nm). Do not apply lubrication to the
activator arm pivot bolt (G).
2. Apply anti-seize compound to the actuator arm
shoulder bolt (D) and the (4) washers. Install the
pivot bolt (D) through the activator arm (F).
3. Install the actuator arm pivot bolt (D) and (4)
washers to the activator arm assembly.
Be sure the (4) washers are positioned correctly:
• Washer 1: Standard Pivot Washer
• Washer 2: Standard Pivot Washer
• Washer 3: Standard Pivot Washer
• Washer 4: Teon Washer
(Fig. 032)
4. Apply Loctite
®
242 to the actuator arm pivot bolt
threads (D).
5. Tighten nut (C) until the control lever has an
acceptable and safe resistance feel when moved
from stop to stop.
- Over tightening nut (C) may damage the Teon
washer and cause excessive resistance.
- Under tightening nut (C) may cause the actuator
arm to feel loose.
(Fig. 033)
Fig. 032 PICT-2085
Fig. 033 PICT-2082
C
1
2
3
4
D
F