Toro titan zx - Motion Control; Actuator Arm Service; Motion Control Disassembly (LH Side)

CHASSIS
3-14
Toro TITAN 2009-2013 Service Manual
3
4. Remove the actuator arm nut (C) and (2) washers
(Fig. 030).
5. Remove the shoulder bolt (D), actuator arm (E) and
the (2) washers from the activator arm (F) (Fig. 030).
Fig. 030 PICT-2082
Motion Control / Actuator Arm
Service
Note: The entire Control Box / Motion control
assembly does not need to be removed
from the frame to service the Actuator Arm
assembly. The fenders and control box are
shown removed from the frame for clarity and
ease of service.
Motion Control Disassembly (LH Side
Shown)
1. Remove the control lever.
2. Remove the upper damper shoulder bolt and washer
(A).
3. Note orientation, then remove the eccentric fastener
(B) and eccentric from the control box (Fig. 029).
Fig. 029 PICT-2079
A
B
6. Remove the activator arm pivot bolt and nut (G) and
the activator arm assembly (F) from the control box
(Fig. 031).
Fig. 031 PICT-2081
7. Inspect the pivot bolts, washers, nylon washers and
bushings for excessive wear, replace if necessary.
F
G
C
D
E