Toro titan zx - Pod; Fender Removal - LH; Pod; Fender Installation - LH

CHASSIS
3-6
Toro TITAN 2009-2013 Service Manual
3
Pod / Fender Installation - LH
1. Lubricate rubber fuel tank neck grommet with soapy
water.
2. Remove fuel cap from fuel tank.
3. Install LH fender assembly onto unit frame. Use care
while installing LH fender as the fuel tank neck slips
through the grommet.
4. Install fuel cap.
5. Install the (3) screws (A) that secure the fender to
the unit frame and torque to specications - 7 ft-lbs.
(9 Nm).
6. Connect battery terminals and lower seat.
(Fig. 010)
Fig. 009 PICT-2065
4. Remove fuel cap.
5. Lift LH fender assembly upward and off the frame.
Use care while lifting fender upward as the fuel tank
neck slips through the rubber grommet.
6. Reinstall fuel cap.
Fig. 010 PICT-2064
Pod / Fender Removal - LH
1. Raise seat and disconnect battery terminals.
2. Remove the (3) screws (A) securing the LH fender to
the unit frame.
3. Lubricate rubber fuel tank neck grommet with soapy
water (Fig. 009).
A
A
A