Toro titan zx - Engine Removal

ENGINE
4-5
Toro TITAN 2009-2013 Service Manual
4
Engine Removal
1. Raise seat and disconnect battery terminals.
2. Safely raise and support rear of unit so rear wheels
are off the ground.
3. Remove PTO belt tensioner spring (A) from the deck
to relieve PTO belt tension as shown in chapter 6
(Fig. 052).
Fig. 052 PICT-2041
4. Remove PTO belt from PTO clutch.
5. Disconnect the wire harness connection to the PTO
clutch.
6. Remove the PTO clutch bolt and then remove the
clutch from the engine crankshaft.
7. Remove the drive belt tensioner spring (B) (Fig.
052).
8. Remove the belt from around the crankshaft drive
pulley and remove the drive pulley from the engine
crankshaft. Make note of pulley orientation for
assembly.
9. If necessary, remove rear engine guard.
10. Remove the fasteners that secure the heat shield to
the mufer and frame and remove the heat shield. If
necessary, remove the mufer from the engine.
11. Remove the (4) engine to frame mounting bolts.
Make note of clutch stop bracket (C) mounting and
orientation (Fig. 053).
Fig. 053 PICT-2055
12. Safely disconnect the fuel and vent lines from
engine.
13. Remove the throttle and choke cable from carburetor
linkage.
14. Disconnect the chassis-to-engine electrical
connection (D).
15. Disconnect the ground wires from the engine block
(E)
16. Disconnect the positive battery cable (F) from the
starter motor (Fig. 054).
Fig. 054 PICT-2056
17. The engine can now be lifted vertically from the
frame.
D
F
E
A
B
C