Toro titan zx - Spindle Disassembly; Spindle Assembly

MOWER DECK
6-16
Toro TITAN 2009-2013 Service Manual
6
Spindle Assembly
1. Fully seat a new UPPER bearing (pulley side) into
spindle housing until it contacts the bearing bore
shoulder. Be sure to press equally on inner and
outer race while installing bearing.
2. Turn spindle housing over.
3. Install the bearing spacer (B) into spindle housing
(C).
4. Install a new LOWER bearing (blade side) into
spindle housing until it contacts bearing spacer and/
or bore shoulder. Be sure to press equally on the
inner and outer race while installing bearing.
Note: While installing lower bearing, align center
bore of the bearing spacer(s) with center bore
of the bearings.
5. Install spindle shaft (D) into spindle housing.
6. Install spindle assembly to the deck as outlined in
this chapter.
7. If necessary, install the deck onto the frame.
(Fig. 115)
Fig. 114 PICT-2035
Spindle Disassembly
1. If necessary, remove deck from the frame as shown
in this chapter.
2. Remove spindle assembly from deck as outlined in
this chapter.
3. Remove spindle shaft (D) from spindle assembly.
Inspect for excessive wear and replace if necessary
(Fig. 114).
4. Use an appropriate punch or bearing extractor
to remove the (2) bearings (A) from the spindle
housing.
5. Inspect bearing spacer (B) for wear and replace if
necessary.
6. Clean and inspect spindle housing (C) bearing bores
for excessive wear and replace if necessary.
D
C
Fig. 115 PICT-2063
A
B
C
A