Toro titan zx - Pod; Fender Service; Pod; Fender Removal - RH; Pod; Fender Installation - RH

CHASSIS
3-5
Toro TITAN 2009-2013 Service Manual
3
Pod / Fender Service
Pod / Fender Removal - RH
1. Raise seat and disconnect battery terminals.
2. Remove the (4) screws securing control panel (A) to
RH fender. Move control panel inward towards the
center of the unit.
3. Remove the (3) screws (B) securing the RH fender
to frame.
4. Maneuver RH fender up and off frame.
Pod / Fender Installation - RH
1. Maneuver RH fender into position.
2. Install the (3) screws (B) that secure the RH fender
to frame and torque to specication – 7 ft-lbs. (9
Nm).
3. Position control panel (A) back onto RH fender.
Install and sufciently tighten the (4) screws that
secure the control panel to the RH fender.
4. Verify choke cable, throttle cable and wiring are
properly routed.
5. Connect battery terminals and lower seat.
(Fig. 008).
Fig. 008 PICT-2061
A
B
B
B