Toro titan zx - Caster Wheel, Bushing & Bearing Service - TITAN MX Chassis; Disassembly; Assembly

CHASSIS
3-4
Toro TITAN 2009-2013 Service Manual
3
Assembly
1. Lightly lubricate bearings (D), bushings (C) and
wheel spanner (B) with No. 2 general-purpose
lithium base grease. Fill center of wheel hub with
grease.
2. Install the (2) bearings (D) and (2) bushings (C) into
front wheel hub, making sure they are fully seated.
3. Install wheel spanner (B) into the front wheel
assembly.
4. Install front wheel assembly into the front caster.
5. Install the nut / bolt (A) and torque nut to
specication - 35 ft-lbs. (47 Nm).
6. Lubricate bushings / bearings through grease tting
with No. 2 general-purpose lithium base grease.
7. Safely lower unit and verify proper function.
(Fig. 007)
Fig. 007 PICT-2060
Caster Wheel, Bushing & Bearing
Service – TITAN MX Chassis
Disassembly
1. Safely raise and support unit so front wheels are off
the ground.
2. Support under caster wheel and remove the nut /
bolt fastener (A).
3. Remove and inspect wheel spanner (B). Replace if
excessively worn.
4. Use an appropriate punch to remove the (2)
bushings (C) from the wheel hub. Inspect bushings
and replace if excessively worn.
5. Remove the (2) bearings (D) from the wheel hub.
Replace if excessively worn.
6. Properly clean and inspect the front wheel hub area.
A
D
B
C