ELECTRICAL
7-13
Toro TITAN 2009-2013 Service Manual
7
PTO Clutch Replacement
PTO Clutch Removal
1. Remove the PTO belt tensioner spring from the
deck, then remove the PTO belt from the PTO
clutch.
2. If necessary, safely raise and support unit.
3. Disconnect harness connection to PTO clutch.
4. Remove the PTO clutch bolt (A).
5. Remove PTO clutch (B) from the engine crankshaft.
Fig. 155 PICT-2062
PTO Clutch Installation
1. Clean engine crankshaft.
2. Apply anti-seize to engine crankshaft.
3. Install PTO clutch onto engine crankshaft. Be sure
anti–rotation bracket is properly aligned.
4. Apply Loctite
®
242 to PTO clutch bolt.
5. Torque the PTO clutch mounting bolt to 55 ft-lbs.
(75 Nm).
6. Connect harness connection to PTO clutch.
7. Install PTO belt, then tensioner spring.
8. Safely lower unit.
9. Verify proper function.
(Fig. 155)
Kawasaki Clutch / Clutch Stop Location Kohler / Briggs and Stratton Clutch / Clutch Stop Location
A
A
B
B
To Next Page
Loading...
