Toro titan zx - Mower Deck Removal (50 Inch)

MOWER DECK
6-12
Toro TITAN 2009-2013 Service Manual
6
7. Remove the hardware from the front deck hangers
on both sides of the deck (Fig. 109).
Fig. 108 g. 70 G010311
Fig. 109 g. 67 G010303
8. Carefully lift the deck off the rear hanger bolts and
lower the front of the mower deck to the ground (Fig.
109).
9. Raise the height-of-cut to the transport position
10. Slide the mower out from underneath the machine.
Mower Deck Removal - 50 Inch Deck
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers outward to the
neutral position, engage parking brake, stop the
engine, remove the key, and wait for all moving parts
to stop before leaving the operating position.
3. Lower the mower to the 3 inch (76mm) height-of-cut
position.
4. Remove the PTO belt tensioner spring, then remove
PTO belt from PTO clutch.
5. Lower the height-of-cut lever to the lowest position.
6. Move the spring loaded J-hooks out of the slot in the
rear hanger brackets on both sides of the deck (Fig.
108).
A B
C
A. Deck hanger E. Rear hanger bolts
B. Hairpin F. J-hook
C. Washer G. Rear deck hanger
D. Welded post on deck bracket
A
B
E
F
G
C
D