HYDROSTATIC DRIVE SYSTEM
5-10
Toro TITAN 2009-2013 Service Manual
5
Transaxle Replacement
Transaxle Removal – RH Side Shown
1. Disconnect the battery terminals.
2. Safely raise and support rear of unit so rear wheels
are off the ground.
3. Remove the rear wheels.
4. Remove the parking brake return spring (A) from the
rod and spring plate.
5. Remove the retaining pin (B) from the brake linkage
then remove the brake rod from the hydro arm.
6. Remove the hydro bypass rod (C), retaining clip, and
washer then remove the rod from the unit.
7. Remove the hydro control rod nut and bolt (D) (Fig.
077).
Fig. 077 PICT-2046
7. Torque the clutch bolt to specication - 55 ft-lbs. (75
Nm).
8. Install the PTO belt around the PTO clutch pulley.
9. Verify proper PTO belt routing and then install the
PTO belt tensioner spring to the deck. See PTO Belt
Replacement and Belt Routing on page 6-5.
10. Safely lower unit and verify proper drive system
function.
D
B
C
A
To Next Page
Loading...
