Toro titan zx - Checking Front-to-Rear Blade Slope

MOWER DECK
6-22
Toro TITAN 2009-2013 Service Manual
6
A. Blades front-to-rear C. Measure from the tip of
B. Outside cutting edges the blade to the at
surface here
Checking the Front-to-Rear Blade Slope
Check the front-to-rear blade level any time you install
the mower. If the front of the mower is more than 5/16
inch (7.9mm) lower than the rear of the mower, adjust
the blade level using the following instructions:
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers outward to the
neutral position, engage the parking brake, stop the
engine, remove the key, and wait for all moving parts
to stop before leaving the operating position.
3. Carefully rotate the blades so they are facing front to
rear (Fig. 123).
4. Measure from the tip of the front blade to the at
surface and the tip of the rear blade to the at
surface (Fig. 123). If the front blade tip is not 1/16-
5/16 inch (1.6-7.9mm) lower than the rear blade
tip, continue to the “Leveling the Mower Deck”
procedure.
Fig. 122 g. 62 G007202
A. Blades side-to-side C. Measure from the tip of
B. Outside cutting edges the blade to the at
surface here
Fig. 123 g. 63 G007199
4. Measure between the outside cutting edges and the
at surface (Fig. 122). If both measurements are not
within 3/16 inch (5mm), an adjustment is required;
continue to the Leveling procedure.
A
B
B
B
C
C
C
C
A
B
B
C
CC
C C C
B
A
A