Toro titan zx - Seat Support; Fender Support Service; Seat Support Removal

CHASSIS
3-17
Toro TITAN 2009-2013 Service Manual
3
Seat Support / Fender Support
Service
Seat Support Removal
1. Raise seat and disconnect battery terminals.
2. Remove RH and LH pod / fender as shown in this
chapter.
3. Remove the (2) bolts that secure the hydro
expansion tank (A) to the seat support.
4. Remove the (1) fastener securing the fuel tank
retaining rod (B) to the seat support.
5. Remove the (2) thread-forming bolts that secure
the rear guard tube (C) to the seat support (E). OR
Remove the bolts / nuts securing the rear engine
guard to the ROPS frame (D) (Fig. 035).
6. Remove the (2) bolts and nuts that secure the seat
support (E) to the frame brackets.
7. Note the location of and remove any cable ties /
loom clamps securing wiring / cables to the seat
support bar (E).
8. Remove the seat support bar from the frame.
(Fig. 036)
Fig. 035 PICT-2070
Fig. 036 PICT-2066
B
C
E
A
D
E
C