Toro titan zx - Page 39

CHASSIS
3-13
Toro TITAN 2009-2013 Service Manual
3
4. Install the oor pan and torque the (2) fasteners to
specication - 7 ft-lbs. (10 Nm).
5. Install the motion control rod and clips and pins (F)
(Fig. 027).
Fig. 027 PICT-2075
F
7. Properly route the wire harness and connect the RH
and LH neutral switches, and parking brake switch.
8. Install the control covers and torque the fasteners to
specication – 5 ft-lbs. (7 Nm).
9. Safely install the fuel tank as shown in this chapter.
10. Install the RH and LH fenders as shown in this
chapter.
11. Install the seat assembly.
12. Install the seat switch harness connection and verify
proper harness routing.
13. Install the (2) control handles and torque the (4)
fasteners to specication - 30 ft-lbs. (40 Nm).
14. Install the battery and battery cables.
15. Verify proper function.
6. Install the parking brake linkage, washer and pin and
(G) (Fig. 028).
Fig. 028 PICT-2076
G