LH & RH Motion Control Assembly Removal (continued)
g421550
Figure 104
8. Using a 1/2 inch socket, remove the (5/16 inch) bolt securing the LH & RH
motion control dampeners to the chassis.
g421551
Figure 105
9. Using a 9/16 inch wrench and a 3/4 inch socket, remove the (3/8 inch)
lock nut and (1/2 inch) shoulder bolt securing the LH & RH motion control
assemblies to the chassis. Remove the LH & RH motion control assemblies.
2000 Series Z MASTER®Service Manual Page 7–7 Drive: Service and Repairs
3460-328 Rev A
To Next Page
Loading...
